Seawind 1190 (11.9 METRES / 39ft )

STANDARD SPECIFICATIONS AND EQUIPMENT – OWNERS 3 Cabin Version

1. GENERAL: 

The 1190 has been developed to meet the evolving needs of modern sailors. The 1190 offers a low maintenance high performing 39ft catamaran with enhanced upwind performance and shallow draft capability offered through retracting daggerboards. Perfect for weekend sails and a great base to begin your offshore cruising dream!

2. EXTERIOR / LAMINATE:

• Finish: Full female moulded hulls & decks, exterior gelcoat finish with molded-in non-slip surface on deck areas
• Hull Laminate: Infused polyester resin laminate with vinylester tie layer
• Hull Core Material: PVC closed cell foam core
• Deck Laminate: Vacuum formed polyester resin laminate
• Deck Core Material: PVC closed cell foam core
• General Laminate: Vacuum formed polyester resin laminate
• General Core Material: PVC closed cell foam core
• Laminate specifications are certified to International CE standards

3. MAST/BOOM/SAILS:

• Clear anodized aluminium mast and boom. Single Spreader, 7/8 rig
• Standing Rigging :

– Forestay 3/8 (10mm) 1 x 19 Dieform wire.

–  Sidestays 3/8 (10mm) 1 x 19 Dieform wire

–  Diamonds 5/16 (8mm) 1 x 19 Stainless Steel wire

• Halyards:

– Main halyard:  12 mm Spectra rope : Heavy duty shackle

– Jib halyard:  8 mm Spectra rope. Heavy duty shackle

– Topping lift:  8 mm rope, Heavy duty shackle

– Boom outhaul: 10mm Spectra

• Single line reefing, run to helm. Three reefing points with 2 reef lines

– Reef 1 & 3: 10mm rope. Leech/Clew blocks and snap shackle

– Reef 2: 10mm rope. Heavy duty shackle

• Sheets:

– Main sheet: 10mm rope

– Main traveller: 8mm rope

– Jib sheet: 10mm rope

• All halyards, reefing lines to be lead back to cockpit through turning blocks, rope clutches
• Fully battened mainsail. Triple stitched reinforced construction. Leach adjustable batten end caps. Fibreglass sail battens
• Mainsail cover with integrated lazy jack system.
• Self-tacking headsail, curved headsail traveller track with end stops. With single line control sheet to cockpit.

4. DECK EQUIPMENT:

• Aluminium Hatches & portholes (9 in total)

– 4 x Forward Hatches 470mm x 470mm

– 2 x Mid cabin hatches 470mm x 470mm

– 1 x Port Bathroom window hatch 507mm x 377mm

– 1 x Galley window hatch 507mm x 377mm

– 1 x Aft Cabin window hatch 507mm x 377mm

• Fibreglass Deck Hatches:

– 5 x Forward anchor & storage hatches

– 2 x Cockpit storage hatches

• 6 x Docking cleats. Each side : bow, stern & amidships
• 6 x Safety handles around cockpit
• 1 x Heavy duty mooring cleat on forward walkway
• Ventilation: 2 x forward cabin hatch vents
• Mast base turning blocks. All halyards & sail controls to cockpit
• 9x Rope clutches
• Sheet winches : 1 x 40ST – 2 speed self tailing, 2 x 50ST – 2 speed self tailing
• Stanchions/Rails: High quality stanchions, bow rails and stern rails with 3 life-lines.  With700mm high lifelines to meet CE requirements
• 2 x transom access gates with pelican hook releases
• 2 x side access gates with pelican hook releases
• Aft swim ladder: folding stainless aft swim ladder

5. FORWARD BEAM, CATWALK AND TRAMPOLINES:

• Carbon reinforced fwd beam
• Pelican striker and adjustable cable
• 1 x Mooring plate above foredeck
• 2 x Anchor roller under deck. Permanent stowage position for 45lb Plough (CQR/Delta type) anchor (cheeks 75mm high)
• Catwalk in PVC foam-sandwich fibreglass
• Light weight plastic coated open netted trampolines

6. AFT BEAM AND DECK:

• Targa Bar with curved mainsheet track and continuous line traveler control system
• Stainless steel framed slatted seats behind aft beam
• Full width hard top over cockpit

7. STEERING SYSTEM:

• Twin helm stations
• 2 X 32” lightweight composite steering wheels
• Both wheels independently linked to steering system. – system offers back-up redundancy
• Retractable dagger boards below deck height when retracted
• Lifting, transom hung rudders

8. INTERIOR FINISH:

• Furniture and cabin sides gloss gelcoat finish
• Cabin top lined with light weight internally molded gelcoat liner
• Floors: synthetic timber flooring
• Lightweight cupboard doors and trimmings

9. SALOON:

• Lightweight handcrafted saloon table
• Upholstered settee
• Lightweight handcrafted coffee table
• Forward aluminium opening windows
• Saloon side windows in 8mm toughened glass
• Tri folding cockpit doors
• Removable low profile, helm hatches

10. GALLEY:

• Spacious galley with coordinated Polystone counter surfaces
• Three (3) burner LPG stove, stainless steel pot holders. Flame failure device to shut off LPG immediately in event of flame going out
• Double bowl stainless steel sink
• Pressure fresh water system
• Refrigerator: Front opening upright fridge 130 litres
• Under bench storage
• Trash bin
• LPG solenoid control in galley

11. SLEEPING CABINS:

• Light weight PVC foam cored doors on all private cabins
• Port & Starboard fwd cabins : Each queen sized bed (2050mm x 1540mm)
• Aft Starboard cabin : Double bed (1990mm x 1230mm)
• Mattresses 150mm ( 6” ) foam upholstered
• Cabins lined
• 12volt LED lighting
• Storage/Cupboards

12. PORTHEAD:

• Polished light weight PVC foam cored door
• Manual toilet. Discharge via holding tank
• Holding tank built in. Discharge pump out by shore station or directly overboard 130L
• Pipes, skin fittings and sea-cocks are easily accessible and to meet survey requirements
• Vanity basin with pressure water
• Separate shower stall with wall mounted shower head & mixer tap
• Electric shower bilge pump with direct overboard discharge
• Large quantity cupboards / shelves to very high quality

13. LIGHTING/ELECTRICAL SYSTEM:

• High quality DC electrical switch panel with circuit breakers, LED indicator lights and voltage display
• Marine grade tinned electrical wiring with extensive use of heat sealed connectors
• Batteries x 2 comprising: 1 x 12v 200Ah Deep Cycle House Gel Batteries. 1 x AGM Start batteries
• 230amp heavy duty isolation switch
• 12V lighting : Numerous 12V interior lamps and courtesy lights throughout including recessed lights in cockpit
• 4 x 12V Outlets
• CE approved navigation lights. Port & Starboard mounted on bow rails
• Deck floodlight mounted on spreaders
• Mast head anchor / riding light
• 2x 125w Solar Panels and 40amp regulator

14. PUMBING /FRESH WATER TANKS:

• Pressure water system with water to galley and bathroom
• Fresh water tank: 700 litres( 185gallons) rotomoulded. Remote deck filler
• Electric fresh water pump
• Electric bilge pumps (2) with controls integral with master battery switch panel
• Manual bilge pumps (2) in each hull
• Marelon through-hull fittings to CE/ISO standard
• Manual toilet in head
• 1 x LPG bottle – 4.5kg
• Fresh water tank gauge

15. ENGINES:

• Twin lightweight Honda 20hp 20” engines. Mounted under each helm seat at each steering station
• 5” leg extensions added to engines to reduce cavitation
• Remote electric key start with electric tilt fitted
• Dual engine controls at port helm station
• 270l fuel tank mounted in external locker fwd of mast

16. NAVIGATION:

• Twin steering compasses

17. ANCHORING /MOORING:

• Primary anchor is 45 lb CQR anchor type with 55 mtrs x 8mm short link galvanised chain.
• Primary anchor is stored in a specially designed anchor roller under the forward beam
• 3 x PVC Inflatable Fenders
• 3 x Mooring lines (each 15 metres x 14mm)

18. ANTIFOULING / STRIPING:

• Epoxy barrier coat plus 2 coats of high quality black antifouling bottom paint
• Seawind 1190 decal on each hull and stern

DISCLAIMER: The specifications above may change at Seawind Catamaran’s discretion.